Accelerated Graphics Port (AGP) is a high speed bus used to create a dedicated pathway between the graphics adapter and the processor

Controller Area Network (CAN) is a bus standard that enables microcontrollers to communicate without a host computer and is often found in automotive applications

CoreConnect is a microprocessor bus architecture for system-on-a-chip (SoC) designs.

Center-tap Terminated (CTT) is a 3.3V memory bus standard

Gunning Transceiver Logic (GTL) is a standard used to provide higher data transfer speeds with smaller voltage swings and is used to drive electronic backplane busses.

High Speed Transceiver Logic (HSTL) is a signaling standard between chips on a circuit board.

Inter-Integrated Circuit (I2C) is a bus that is used to connect peripherals to an embedded system

Lightning Data Transfer (LDT) is a bus interconnection standard that allows for fast data transfers.

Low-Voltage CMOS (LVCMOS) is a set of interface standards for connecting digital integrated circuits

Low-Voltage Differential Signaling (LVDS) is a digital signaling system that enables a high speed connection over pair of wires.

Low-Voltage TTL (LVTTL) is a set of interface standards for connecting digital integrated circuits

MultiMediaCard (MMC) communication protocols provide for a serial interface to the memory card

The Non-Volatile DDR2 (NV-DDR2) interface promises speeds up to 400MB/s

Other IP includes many additional types of Bus Interface IP

Parallel port busses are used in computers for connecting various peripheral devices

Peripheral Component Interconnect (PCI) is a standard bus for connecting hardware devices in computing applications

Peripheral Component Interconnect Express (PCI Express) is a expansion card standard which is used in a wide variety of computer applications

Low-Voltage Positive Emitter-coupled Logic (PECL) is a high speed differential signaling standard

RapidIO is a high performance interconnect technology for connecting chips on a circuit board

Reduced Swing Differential Signaling (RSDS) is a differential I/O standard for interfaces between the timing controller and column drivers on display panels.

Secure Digital (SD) communication protocols vary depending on the type and capacity of the non-volatile memory card

Stub Series Terminated Logic (SSTL) is a group of I/O standards commonly used with Double Data Rate (DDR) DRAM memory modules

Universal Serial Bus (USB) establishes a communication channel between a set of devices and a host and is found in both computing and mobile applications